Handrails Proof Loading Testing

The devise was developed in conjunction with a offshore drilling contractor. It allows for proof testing of offshore drilling rig handrails utilizing an adjustable hydraulic arm drive by rig air system.

Technical Specification.

87 psi produces a horizontal force of 200 lbs.
Constructed from 2-inch round pipe, schedule 80.
Weights approximately 50 lbs.

OSHA standard 29 CFR 1910.23(e)(5)(iv) stated the following:

Handrails shall be capable of withstanding a load of at least 200 lbs. applied in any direction at any point on the rail. TOS has tested at intervals of 20, 25, 50 and 75 feet, it is recommended the collective protection should be tested and inspected at frequencies not exceeding 12 months.

For rental

Reconditioning of steel wire ropes

For rental

TOS Hydrostatic Testing

ASME B31.1 Hydrostatic Test	Power piping is normally tested under the procedures outlined in ASME Section B31.1. For hydrostatic testing, the ASME hydrostatic test pressure is 1.5 times the design pressure.
ASME B31.3 Hydrostatic Test	Process piping is tested under ASME Section B31.3. The ASME b31.3 hydrotest is performed at 1.5 times the design pressure.
ASME B31.5 Hydrostatic Test	ASME B31.5 hydrostatic testing code covers refrigerant, secondary coolant piping, and heat transfer components. These hydrostatic pressure testing standards apply to piping that can be used for temperatures as low as -320°F (-196°C).